Overview
This article covers replacing hinge boxes with stripped threads in a FUYL Locker (MK1).
Tools needed:
- Electric drill
- Long nose pliers
- Vice grips
- Rivet gun
Procedure
- Find the retention plate Lay the locker on its back and locate the hinge rod retention plate on its base. This demo uses a 5-door unit, so your retention plate may have more rivets.
- Remove the rivets Begin removing the rivets.
- Remove the retention plate Once the rivets have been drilled out.
- Lever out the hinge rod Use pliers or vice grips to lever it out towards the base of the unit.
- Pull out the rod When enough of the pin is exposed, hold the end of the rod with vice grips to make it easier to pull out.
- Keep the washers As the rod comes out, the doors drop and the washers between hinge boxes will most likely fall out. Keep them, as they’re reused when the rod goes back in. This is a 5-door unit, so the control door is in a different position to a 15-door unit.
- Note the hinge springs Note their position. They need pre-tensioning (half a turn or so) when you replace the hinge boxes.
Replace the hinge boxes
- Swap the hinge boxes Once the hinge rod has been pulled out enough of the way to release the problem doors you can unscrew the stripped hinge boxes and replace them with the new hinge boxes.
- Refit the hinge rod Then using the springs and the washers you have kept, thread the hinge rod back through the hinge blocks, taking care to line up the washers as the rod enters and exits the hinge box.
- Refit the retention plate When the rod has been inserted back into its original position, align the hinge rod retention plate and fix back into place.
You are now complete, having replaced the hinge boxes with stripped threads.