Overview
In some cases, it may be necessary to completely reset your FUYL Locker to factory settings using the latest firmware. Please only attempt this procedure after being advised by support, as there may be special requirements or circumstances to be considered on our side.
Prerequisites
- A FUYL 15 or 5 (MK2)
- An administrator override key
- A MicroSD card reader & a computer
- A new 8Gb, Class 10+ MicroSD card (optional)
Details on how to identify a FUYL locker can be found here. It is recommended to replace the original SD card with a new one to guarantee the longest life possible.
Procedure
Replacing the card takes four stages, each described below.
- Remove the card At the locker.
- Flash the firmware At a computer.
- Reinsert and power on At the locker.
- Test and configure Enrol it, or set up Standalone mode.
At the locker
- Power down the locker Remove power entirely and wait 30 seconds, as a precaution.
- Open the Control Door On the front of the locker, with the administrator key.
-
Remove the MicroSD card From the Control Door.
At the computer
- Download the firmware Download and extract the latest firmware image.
- Install Balena Etcher Or use your own flashing tool if you prefer.
- Flash the card Use the card reader and Etcher to flash the .img file, replacing everything on the card. Contact support if you need help.
At the locker
- Insert the new card Insert the freshly imaged MicroSD card, the right way round.
- Close and lock the Control Door
- Power on the locker Wait for it to start up fully. This may take a while as each lock module adopts the new firmware.
Testing and configuration
Cloud enrolment
If the locker will be connected and managed from the Essentials, Advanced, Classic or Enhanced services, support will need to perform tasks to allow what appears to be a new locker to enrol. Please contact support before continuing with any enrolment.
Offline use (Public/Standalone mode)
If the locker will not be connected or managed remotely;
- Open setup At the "Ready to set up" screen, press "00" then "OK" on the pin-pad.
- Enter the default PIN At the prompt for an Admin PIN or RFID, enter "31082018" to open the default admin menu.
- Select "Standalone mode" And confirm the selection.
- Wait for a restart The locker may restart to apply the new mode.
- Set a new admin PIN Once "Enter bay number" appears, reopen the admin menu and set a new administrator PIN and/or RFID.