Overview
This article covers replacing the USB port in a FUYL Locker (MK1).
Tools you will need:
- Battery operated Screwdriver
- Torx-Head Screwdriver bit
- Phillips-Head Screwdriver bit
- Cable Cutters
Procedure
Move the power point
- Power down the locker Unplug it and wait 30 seconds for any power to dissipate.
- Remove the side panel Undo the 20–25 Torx screws on the side and front panels. This is what you’ll see with the side panel removed.
- Cut the cable ties Cut the cable ties holding the power point cable and the USB port label, so the process goes smoothly.
- Unscrew the power point From inside the locker. There’s a second screw that’s hard to see.
- Move the power point out of the way It’s best to move the cable from the power point above as positioned below. This can be quite tough, but it’s easier with the cable ties removed.
- Slide out the power point Pop the left-hand side of the power point out of the socket, and slide the whole unit out.
Remove the USB port
- Slide out the bracket Behind the USB port is a metal retaining bracket. It simply slides out towards you.
- Push the USB port into the locker Squeeze the back of the port and push it in. It may take a bit of force.
- Unplug it from the USB hub Follow the USB cable back to the USB hub and remove it.
- Remove the broken USB port
Fitting a new USB Port:
To replace this part, follow these instructions in reverse, fitting the USB port, metal bracket, power point and cable ties in that order. Once you have removed the port you will find it is a relatively simple process.