Overview
New firmware is installed on a FUYL Locker (MK1) by replacing its SD flash card. This article covers swapping the card, then running the diagnostic tests the locker prompts for when it starts up again.
Procedure
Replace the card
- Switch off the locker Switch off the power, and wait at least 30 seconds.
- Open the control door Using the access key.
- Find the SD card Looking from above, in front of the door, find it on the edge of the lower control board, below the lithium clock battery.
- Remove the SD card Press and release it, then pull it out of the socket.
- Insert the new SD card Insert it into the socket, gold contact side up, and press it in until it clicks.
Start up and test
- Switch on the locker Wait 2–3 minutes while the SD card is prepared and the controller boots.
- Run the diagnostic tests Follow the prompts on the display.
- LCD test: If the displayed characters are readable, press OK.
- Keypad test: Press each key as prompted.
- Door / Lock test: Close all doors as requested. Each door will be unlocked sequentially. As each door opens press OK to confirm.
- Admin key test: Rotate the admin keyswitch as prompted.
- Nameplate S/N: Enter the last 4 digits of the plate attached to the base of the locker and press OK.
- Set up the locker Connect the locker’s LAN cable to a network or laptop, and set it up from the Management portal. If the locker hasn’t been set up before, see the FUYL Locker User Manual and Management Portal User Manual.