Overview
In rare circumstances, the gray data cable connections in MK2 lockers may become loose over time, particularly with repeated forceful closing of the bay doors. This may result in individual bays not responding properly, but reseating the data cable connections is a simple maintenance procedure that can restore proper communication between the locks and the control system.
Important Notes & Advisories
- Gentle Handling: Always handle cable connections with care. The connectors are designed to seat securely but should not require excessive force.
- Power Safety: Always power down the locker completely before performing any maintenance procedures to avoid electrical damage or system errors.
- Recurring Issues: If the same bay repeatedly requires cable reseatting, this may indicate a more serious hardware issue that should be addressed by support.
Procedure
Follow these steps to reseat the data cable connections in your MK2 FUYL Locker.
- Power down the locker Unplug it, and wait for all lights to turn off.
- Open the side access door The left side access door.
-
Find the data cable The gray cable runs between the control module and each lock connector, and may be partly hidden behind the front chassis corner.
- Reseat each connector Press each one gently until it stops and feels secure. A firm, gentle press is all that’s needed.
- Close the door Make sure it latches properly.
- Power on the locker Let it finish its startup sequence.
- Test the bays Check the previously affected bays now respond properly.
If Issues Persist
If bays continue to malfunction after reseating the data cable connections, a bay readdress procedure may be required. This process reassigns the bay identifiers and can resolve communication issues that are not related to physical cable connections.
When to Contact Support
Contact our support team if you experience any of the following:
- The same bay repeatedly requires cable reseatting after normal use
- You notice damaged cables, connectors, or visible wear on the wiring
- Bays continue to malfunction after both cable reseatting and bay readdressing
- You are uncomfortable performing any of the maintenance procedures described