Overview
Your FUYL™ Locker's local functions are all controlled by a small computer located behind the Control Door (Where the PIN pad, RFID reader and screen are situated). To connect to your network via ethernet, there is an internal ethernet cable running from that computer's network adapter to a female-female connector on the back of the locker's chassis. In rare cases this cable may need testing or replacement if instructed by a support staff member.
What model FUYL Locker do I have?
Check out our article on Identifying a FUYL Locker.
Process
Remove the old cable
- Power down the locker Unplug it and wait 30 seconds for any power to dissipate.
- Open the Control Door Compartment Wear an anti-static strap, as the control door is easily damaged by electrostatic discharge.
-
Disconnect the cable from the control door This differs between doors. MK2 (FUYL): unclasp the two Velcro straps, disconnect the Ethernet Cable and remove the Ferrite Core from it. MK3 (FUYL Pro): disconnect the Ethernet Cable, remove it from the Ferrite Core, then from the cable-tidy (you may need to unwrap it).
- Open the Maintenance Access Panel
-
Remove the cable Disconnect the Ethernet Cable from the Ethernet Socket and remove it.
Fit the new cable
-
Install the new cable Reverse steps 5 and 3. For MK2 doors, check the notes below.
- Check the Control Door Make sure cable routing in the Control Door Compartment is neat and secure, and that the door opens and closes easily, locks securely and doesn’t foul or chafe on the cables.
- Check the Maintenance Access Panel Make sure cable routing is neat and secure, and that the panel opens and closes easily, locks securely and doesn’t foul or chafe on the cables.
MK2 doors:
- The Ethernet Cable MUST NOT extend past the edge of the PCB.
- The Data Cable MUST have an allowance of slack in the cable on the PCB side.
- The earth cable MUST be orientated toward the hinge.
- Make sure the Speaker Wire is securely tucked away under the steelwork.
- Make sure none of the cable connections to the Control Door have become loose in handling.