Overview
This guide will take you through replacing a FUYL Locker bay door.
Tools Required:
(1) T20 Torx screwdriver
Process:
Remove the old door
- Swap the number window Undo the 3 screws on the inside of the door to remove it, and install the new number window in the same place. Make sure it matches the number sequence on the locker.
- Unscrew the door Remove the 3 screws connecting the door to the hinge.
- Slide the door off Slide it away from the hinge to separate them.
- Remove the hinge from the pin The spring stays in place.
Fit the new door
- Separate the new hinge Remove the hinge from the replacement door and separate its two parts.
- Fit the female half Install the female half of the hinge around the pin and spring.
- Join the hinge halves Rotate the female half around the pin, keeping the spring nested inside the hinge, then press the male half into it.
- Slide on the new door Press the two halves firmly together, then slide the replacement door over the hinge’s arm.
- Replace the screws Refit the screws connecting the hinge and door.