Overview
In some scenarios it may be necessary to replace the control door of a FUYL Smart Locker. This process should only be completed on the advice of FUYL Support, and differs depending on FUYL model.
Prerequisites
- Torx T20 Screwdriver (provided with all FUYL Lockers)
- FUYL Admin Key (provided with all FUYL Lockers)
- 7mm socket & driver or wrench
Procedure
FUYL 8 & 23 (MK4)
- Disconnect power Unplug the locker at the wall.
- Open the left side access door
-
Release the display door Pull the display door release pin to free it, then open the display door.
-
Disconnect the cables Disconnect the power, USB-C, data and ethernet cables from the back of the display door.
-
Unscrew the door Unscrew the 3 bolts securing the door to the hinge with the included T20 screwdriver (or your own), taking care when disconnecting the grounding cable.
- Slide the door from the hinge
- Fit the new door Insert it in the same position, then follow the steps above in reverse. Make sure the grounding cable is connected.
FUYL 5 & 15 (MK2, MK2.5 & MK3)
While the MK3 FUYL Control Door differs from the MK2 in appearance, it is backward compatible and will seamlessly replace an older MK2 door.
- Disconnect power Unplug the locker at the wall.
-
Open the control door Using the admin key.
-
Disconnect the cables Disconnect all three cables (power, data and ethernet) leading from the internal wiring loom to the back of the control door, whatever the model. Amber arrows mark connections that may differ between models.
-
Disconnect the grounding lead Carefully disconnect it from the interior chassis with a 7mm socket or wrench.
-
Remove the door Unscrew the 3 bolts securing the door to the hinge with the included T20 screwdriver (or your own), then slide the door away from the hinge.
- Fit the new door Insert it in the same position, then follow the steps above in reverse.
Important notes:
- The new door includes a new grounding cable, ensure this is connected to the chassis correctly
- The data cable may differ between models, take care when reconnecting cables that the connector matches exactly
Next Steps
After replacing a control door, you will likely need to re-address the locks to ensure they communicate correctly with the new control system.
Please refer to the Address Locks article for detailed instructions on completing this process.